Documents

application 1 page

Also attached to this agenda item: 80 Morningside A-1 CONST DWG 80 Morningside Neighbor Letters of Support 80 Morningside ZBA REDACTED application 80 Morningside Zoning Site Survey 80 Morningside Zoning Site photos 01-S-1 SITE PHOTOS 80 Morningside previous ZBA variance

12" FOOTINGS TO 42" BELOW GRADE -3'-6" 0" 8R@8-1/4" MAX 7R@ 8-1/2" MAX X4 POST X4 SUPPORT X4 SUPPORT 0"H PICKET W/ BETWEEN 2X8 RIM JOIST (3) 2X8 DROP GIRDER 2X8 RIM JOIST (3) 2X8 DROP GIRDER 6X6 PT POST EXIST DR TO BE RE-TRIMMED ROOFING OVER EXIST DR TO BE REDONE EXIST DR TO REMAIN 5 4" COMPOSITE DECKING AS SELECTED BY HOMEOWNER 2x10" JOIST 12"O.C. (3) 2x12 GIRDER 5 x 10 NAILS GALV. STRAP ANCHOR 6x6 P.T. POST COPPER FLASHING OVER EPDM ROOFING & FRAMING LEDGERLOK TYPE FASTENERS 24"O.C. MAX JOIST HANGER 12" DIA. CONC. FOOTING 2x6 WOOD RAIL CAP 2x4 STRETCHER UNDER HANDRAIL 1/4" S.S. CABLE RAIL SYSTEM 2x10 BLOCKING @ 4x4 POST 2x10 RIM JOIST (2) 3/8" BOLTS @ EA. POST 3/4" x FASCIA BOARD 4x4 P.T. POST 1 SIMPSON DTT1Z DECK TENSION TIE. FASTENED TO EXIST SILL PLATE EA. END OF DECK W/ ADD TIES AT 1/3 POINTS ALONG DECK LENGTH AT HOUSE. SILL PLATE FASTENER TO HAVE 3" MIN EMBEDMENT EXIST DOOR TO REMAIN EPDM ROOFING UNDER DECKING DRAPED BETWEEN JOISTS & SLOPED AWAY FROM HOUSE AZAK TYPE BEAD 7 BOARD PANELS ATTACHED TO THE UNDERSIDE OF THE DECK, TO STOP 1-1/2" FROM RIM JOIST / FASCIA GAP IN WOOD TO ACT AS A DRAIN 2x10 P.T. LEDGER LINE OF EXIST HOUSE GALV. BASE CONNECTOR 1/2" "J" BOLT FINISH GRADE A-2 1" 8" 11" MAX 3-3/4" BLUESTONE SPACE IN TRIANGLE UNDER RAIL NOT TO ALLOW A 6" SPHERE TO PASS THROUGH, PER NYS RES. CODE 2x6 STAIR TREADS 2x8 RIPPED TO SIZE 2x12 STRINGER 1" NOSING DIA. LESS THAN 6" DECKING -3'-6" 12" FOOTINGS TO 42" BELOW GRADE 6X6 PT POST EXIST GRADE 2X8 RIM JOIST (3) 2X8 DROP GIRDER 8@ 8-1/4"MAX 7@ 8-1/4"MAX 3'-0" 2X8 RIM JOIST LINE OF HOUSE 3-3/4" SPACING MAX. . 3-3/4" SPACING MAX. . 6'-0" 4X4 POST 2X4 SUPPORT 2X4 SUPPORT 6'-0"H PICKET W/ 2" BETWEEN FLUSH MTD CLG FAN AS SELECTED BY HOMEOWNER SURFACE MTD OVERHEAD LED LIGHT FIXTURES AS SELECTED BY HOMEOWNER 5'-0" 8'-0" SWITCHING AS DIRECTED BY HOMEOWNER 5'-0" 7'-0" 2'-0" 2'-0" 3'-0" BEAD BOARD CEILING @ UNDER SIDE OF FRAMING DN DN WATERPROOFING MEMBRANE TO SLOPE TO GUTTER NEXT TO DROP BEAM DROP BEAM GUTTER MTD TO BEAM EPDM RUBBER ROOF TO BE FULLY ADHERED TO REBUILT AREA OVER DOOR & TO EXTEND UP AND UNDER EXIST DOOR SILL EXIST AWNING TO BE REMOVED BACK TO EXIST SHEATHING TO PREP AREA FOR NEW CONSTRUCTION - REPAIR AS REQ'D EPDM RUBBER ROOF FLASHED OVER MTL DRIP EDGE AND UP NEW ROOFING BLACK MTL CAP FLASHING OVER DOOR & ALONG LENGTH OF HOUSE WHERE LEDGER IS BOLTED TO HOUSE DOOR TRIM TO BE REPLACED TO MATCH EXISTING C LR CROTON-ON-HUDSON, NEW YORK A R C H I T E C T 3 WINDSOR ROAD TEL (914) 330-1802 L E W I S C R O A N E LEWISROANEDESIGN@GMAIL.COM AS NOTED ELEVATIONS & DETAILS A-2 EXIST DECK TO BE REMOVED IN ITS ENTIRETY 7/25/2020 2020-20 12. 13. 14. ELECTRICAL NOTES 1. 2. 3. 4. 7. 5. 6. 8. 9. 10. 11. ALL ELECTRICAL WORK IS TO BE PERFORMED BY A LICENSED ELECTRICIAN ALL FIXTURES AND FINISHES ARE TO BE SUPPLIED BY OWNER & INSTALLED BY G.C. U.O.N. ALL MATERIAL USED SHALL BE NEW, BEST OF THEIR RESPECTIVE KINDS, FREE FROM DEFECTS AND CONFORM TO THE REQUIREMENTS OF ALL LOCAL, STATE, AND NATIONAL AUTHORITIES HAVING JURISDICTION. SUBCONTRACTORS SHALL FILE FOR PLUMBING AND ELECTRICAL PERMITS, PAY FOR ALL FEES AND HAVE THEIR WORK INSPECTED BY STATE AND LOCAL AUTHORITIES HAVING JURISDICTION. CONTRACTOR SHALL SECURE ANY AND ALL CERTIFICATES OF COMPLIANCE AND/OR INSPECTION ISSUED BY SAID AGENCIES. ANY MODIFICATION OR CHANGE CALLED FOR BY AUTHORITIES HAVING JURISDICTION SHALL BE MADE WITHOUT ADDITIONAL CHARGE. ARCHITECTURAL DRAWINGS FOR PLUMBING AND ELECTRICAL ARE DIAGRAMMATIC AND INDICATE THE GENERAL ARRANGEMENT OF THE WORK REQUIRED. EACH CONTRACTOR SHALL COORDINATE HIS WORK WITH ALL OTHER TRADES AS REQUIRED TO AVOID INTERFERENCES AND INSURE PROPER INSTALLATION. ALL SUBCONTRACTORS SHALL LAY OUT THEIR WORK IN ADVANCE SO ALL NECESSARY ACCOMMODATIONS FOR IT CAN BE MADE AS REQUIRED. UNNECESSARY CUTTING OF THE STRUCTURE IS TO BE AVOIDED. SHOULD A CONTRACTOR REQUIRE CUTTING FOR THE INSTALLATION OF HIS WORK HE SHALL COORDINATE HIS REQUIREMENTS WITH OTHER CONTRACTORS AND THE ARCHITECT AND PAY ALL COSTS FOR SAID CUTTING, STRENGTHENING, AND ANY PATCHING THAT MAY RESULT. ALL WORK SHALL BE INSTALLED READILY ACCESSIBLE FOR OPERATION, MAINTENANCE, AND REPAIRS. EQUIPMENT INSTALLED AS A PART HEREOF IS TO BE FULLY GUARANTEED FOR ONE (1) YEAR AGAINST FAULTY PARTS AND WORKMANSHIP FROM THE DATE OF ACCEPTANCE OR FINAL PAYMENT, WHICHEVER COMES LATER. ANY RIGGING AND HOISTING REQUIRED BY ANY CONTRACTOR SHALL BE DONE BY HIM AS A NORMAL PART OF HIS INSTALLATION PROCEDURES. ACCESSORIES NEEDED TO MAKE THE INSTALLATION OF EACH SUBCONTRACTOR PERFECT AND COMPLETE IN ALL RESPECTS AND READY FOR OPERATION, EVEN IF NOT PARTICULARLY CALLED FOR, SHALL BE FURNISHED, DELIVERED AND INSTALLED HEREIN WITHOUT ADDITIONAL COST. INCLUDED HERE UNDER SHALL BE, BUT NOT LIMITED TO, THE INCIDENTAL OR MINOR ITEMS THAT ARE NOT SHOWN OR SPECIFIED, BUT WHICH ARE CONSIDERED AS NECESSARY FOR THE PROPER FUNCTIONING OF THE INSTALLATION BY TRADE CUSTOM AND/OR STANDARD PRACTICE, OR SPECIAL REQUIREMENTS OF AUTHORITIES HAVING JURISDICTION. WHERE OUTLETS AND SWITCHES ARE PLACE IN CABINETRY, PANELING OR MOLDING, THE CARPENTER, NOT THE ELECTRICIAN, SHALL MAKE ALL CUTS. UNLESS OTHERWISE NOTED, ALL WALL SWITCHES SHALL BE MOUNTED 3'-0" .FF.. TO CENTER AND ALIGN WITH DOOR HARDWARE AT 3'-0" A.F.F. ALL MULTI-GANG FACE PLATES SHALL BE ONE PIECE. ALL MATERIAL, EQUIPMENT, AND FIXTURES, INCLUDING THOSE SUPPLIED BY OWNER AND INSTALLED BY G.C., MUST BE IN COMPLIANCE WITH U.L. PROPOSED PROJECT SHALL COMPLY WITH THE NEW YORK STATE BUILDING CODE FOR RESIDENTIAL (2020 NYS RESIDENTIAL CODE, 2020 PLUMBING CODE OF NYS, NATIONAL ELECTRIC CODE 2017 OF NYS) REFLECTED CEILING NOTES 5. 6. 4. 1. 2. THIS LIGHTING PLAN IS FOR REFERENCE ONLY ALL LIGHTING LOCATIONS AND FIXTURE TYPES ARE TO BE BY THE HOME OWNER AND INSTALLED BY G.C. U.O.N ALL NEW SWITCHES ARE TO NEW DECORA TYPE SWITCHES COORDINATE THE TEL/ DATA / CABLE OUTLETS W/ OWNER ALL NEW DOWNLIGHTS ARE TO BE EXTERIOR RATED CONTRACTOR TO COORDINATE FINAL LOCATION & TYPE OF LIGHTING FIXTURES WITH OWNER BEFORE INSTALLATION 3. ALL NEW SWITCH LOCATIONS ARE TO BE CONFIRMED IN THE FIELD WITHT THE OWNER 15. NO BEDROOMS ARE ADDED AS PART OF THIS DESIGN